Comskip Support Forum
http://www.kaashoek.com/comskip/

ignore_side setting
http://www.kaashoek.com/comskip/viewtopic.php?f=2&t=1679
Page 1 of 1

Author:  gonzo90017 [ Mon Aug 03, 2015 4:16 am ]
Post subject:  ignore_side setting

I was looking at the .ini file, and was wondering if this setting is usable. I've noticed in my US OTA programming that most if not all of the programming always has the logo on the right side. So if this option is usable I would like to know. And if so what to set it to so it can ignore the left side.

Author:  erik [ Mon Aug 03, 2015 5:13 pm ]
Post subject:  Re: ignore_side setting

When you set
verbose=10
and run comskip the log file will show all available settings.
If you need one, copy it to the ini file.

Or you can try the comskip ini editor.

I do not know anymore if I ever did implement this
You can at least ignore the top or bottom half of the screen when searching for logo

Author:  gonzo90017 [ Tue Aug 04, 2015 1:18 am ]
Post subject:  Re: ignore_side setting

The problem is that the .ini editor doesn't know if the setting was ever implemented either...

Author:  erik [ Tue Aug 04, 2015 6:17 pm ]
Post subject:  Re: ignore_side setting

There is a
ignore_side=
defining the pixels to ignore starting from the side but this parameter works equal on both sides
So the answer is: no

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/