Hi Erik,
I also live in the Netherlands, is it possible for you to post your init file here?
Cheers Richard
init file for the netherlands
Re: init file for the netherlands
This ini file works for the Netherlands, all channels except BBC (because there is no logo)
and Discovery (always a logo)
YOu can make it more agressive by setting
detect_method=111
and Discovery (always a logo)
YOu can make it more agressive by setting
detect_method=111
Code: Select all
detect_method=47 ;1=black frame, 2=logo, 4=scene change, 8=fuzzy logic, 16=closed captions, 32=aspect ration, 255=all
verbose=0 ;show a lot of extra info, level 5 is also OK, set to 0 to disable
ticker_tape=0
max_brightness=60 ;frame not black if any pixels checked are greater than this (scale 0 to 255)
test_brightness=40 ;frame not pure black if any pixels checked are greater than this, will check average brightness (scale 0 to 255)
max_avg_brightness=20 ;maximum average brightness for a dim frame to be considered black (scale 0 to 255) 0 means autosetting
max_commercialbreak=600 ;maximum length in seconds to consider a segment a commercial break
min_commercialbreak=30 ;minimum length in seconds to consider a segment a commercial break
max_commercial_size=150 ;maximum time in seconds for a single commercial or multiple commercials if no breaks in between
min_commercial_size=4 ;mimimum time in seconds for a single commercial
min_show_segment_length=120; any segment longer than this will be scored towards show.
non_uniformity=500
max_volume=250 ; any frame with sound volume larger than this will not be regarded as black frame
intelligent_brightness=0 ;
delete_logo_file=0 ; set to 1 if you want comskip to tidy up after finishing
give_up_logo_search=2000
output_framearray=1 ; create a big excel file for detailed analysis, set to 0 to disable
connect_blocks_with_logo=1 ; set to 1 if you want successive blocks with logo on the transition to be regarded as connected, set to 0 to disable
logo_percentile=0.92 ; if more then this amount of logo is found then logo detection will be disabled
logo_threshold=0.70
aggressive_logo_rejection=0
cut_on_ar_change=1 ; set to 1 if you want to cut also on aspect ratio changes, set to 0 to disable
delete_show_before_or_after_current=1
delete_show_after_last_commercial=1; delete the last block if its a show and after a commercial
shrink_logo=5 ; Reduce the duration of the logo with this amount of seconds
output_videoredo=0
output_cuttermaran=0
output_womble=0
output_mpgtx=0
output_training=0
output_edl=0
output_zoomplayer_chapter=0
output_zoomplayer_cutlist=0
padding=0
live_tv=0
edge_level_threshold=5
edge_radius = 2
excessive_length_modifier=0.1
ar_wrong_modifier=10.0