Updated to the latest version last night. Am now getting .log files that simply just say "Could not open video codec" and now ads are not being detected. I'm doing live detection with SageTV recordings.
I also noticed that the logo files are not being deleted.
No Ads Detected, Could Not Open Video Codec
Re: No Ads Detected, Could Not Open Video Codec
Seems to work fine if I run it manually outside SageTV.
Re: No Ads Detected, Could Not Open Video Codec
make sure there is a 10 minutes delay after the start of the recording before comskip is started
Re: No Ads Detected, Could Not Open Video Codec
Can I do that with the standoff option?
Re: No Ads Detected, Could Not Open Video Codec
MMm, what tool do you use to start comskip?
Re: No Ads Detected, Could Not Open Video Codec
The Commercial Detector plug-in for SageTV. It doesn't have a delay option. Just a live option.
I don't believe I've had a problem with this till last night.
The standoff option is currently set at 8000000.
I don't believe I've had a problem with this till last night.
The standoff option is currently set at 8000000.
Re: No Ads Detected, Could Not Open Video Codec
If it suddenly appeared then some broadcast must have changed
Re: No Ads Detected, Could Not Open Video Codec
This morning I did a live test again. Same result. Downgraded back to 0.81.076 and the issue has gone away. Did a live test again and it ran for over an hour without issue.