Hello,
I'm struggling with a channel in the UK called Quest. I cannot get commercials detected accurately but in looking at the CSV file I can see that when logo=0 and Scene Change = 0 then that is the start or end of an add break. Is there a way I can use this to set up a ini file such these are used as cut points?
Thanks in advance,
Mark.
Detect on Logo and Scene change
Re: Detect on Logo and Scene change
Try
before_logo=x
after_logo=x
where x is the number of seconds to search for a cutpoint before or after a logo appears
before_logo=x
after_logo=x
where x is the number of seconds to search for a cutpoint before or after a logo appears
Re: Detect on Logo and Scene change
Thank you for the reply. Sadly no luck with that. I tried it with the standard comskip.ini file and also the minimal one from the tuning guide with no success.
I probably should have said that at each of the commercial points there is only one frame with both 0 for the logo and 0 for the Scene Change.
Any other suggestions would be appreciated.
regards
Mark
I probably should have said that at each of the commercial points there is only one frame with both 0 for the logo and 0 for the Scene Change.
Any other suggestions would be appreciated.
regards
Mark
Re: Detect on Logo and Scene change
Please follow the "how to ask for help" post