Could not allocate memory for logo frame buffer

Here you can ask your questions on how to use Comskip for the detection of commercials. Also questions on how to remove commercials are welcome
Post Reply
Rugby-Tank
Posts: 3
Joined: Fri Jan 06, 2023 11:00 am

Could not allocate memory for logo frame buffer

Post by Rugby-Tank »

Having previously had comskip running sucessfully from a post processing script in TVHeadend, it has stopped working and has the following message in the log file (after the comskip.ini information) "Could not allocate memory for logo frame buffer" 36 or 37

Any suggestions?

The hardware is a Synology DS218j running DSM 7.1.1-42962 Update 3
erik
Site Admin
Posts: 3368
Joined: Sun Aug 21, 2005 3:49 pm

Re: Could not allocate memory for logo frame buffer

Post by erik »

Comskip requires a fair amount of memory.
I guess there is insufficient memory in your NAS
Rugby-Tank
Posts: 3
Joined: Fri Jan 06, 2023 11:00 am

Re: Could not allocate memory for logo frame buffer

Post by Rugby-Tank »

The DS218J has 512MB of DDR3 memory and a 2GB swap file.

Previously comskip had previously run sucessfully, so must be a close thing. Any suggestions to reduce RAM usage, etc. to get it working again?
erik
Site Admin
Posts: 3368
Joined: Sun Aug 21, 2005 3:49 pm

Re: Could not allocate memory for logo frame buffer

Post by erik »

You will have to rebuild with less logo buffer but this make logo recognition less reliable
Rugby-Tank
Posts: 3
Joined: Fri Jan 06, 2023 11:00 am

Re: Could not allocate memory for logo frame buffer

Post by Rugby-Tank »

I guess you mean adjusting comskip.ini values.

I could just disable Logo as a detection method, but that would affect detection a lot.

So, the likely candidates would be Logo finding, i.e. border, give_up_logo_serch, etc.

Any suggestions?
Post Reply