Italian channels

Here you can post working ini files
Use the country name as the subject line. Do include names of broadcasters this ini works for at the top of the post. Additional ini files for the same country an be added by replying. Discussion to be done in Tuning forum.
Post Reply
palla89
Posts: 1
Joined: Tue Oct 17, 2023 11:23 am

Italian channels

Post by palla89 »

Hi! I didn't find anywhere a .ini for Italian channels, so this is mine. It works insanely good for Mediaset channels.
It also works for RAI 1, RAI 2 and RAI3 (didn't test others) but some tuning could be done because sometimes there are small TG1 / TG2 news and they aren't detected as ads (probably because of their duration)

The turning point for this working was to totally disable the logo detection as a method, because the logo is always present.
here's the ini:

Code: Select all

verbose=10
detect_method=253
delete_logo_file=1
use_existing_logo_file=1
output_framearray=1
output_debugwindow=1   ; Only for tuning, to be replaced later
non_uniformity=100         ; Only for tuning, to be replaced later
max_avg_brightness=20
test_brightness=40
intelligent_brightness=0
logo_present_modifier=0
punish_no_logo=0
min_black_frames_for_break=3
max_volume=100
maxbright=30
max_brightness=30
min_commercial_size=4
min_commercialbreak=15
max_commercialbreak=600
max_commercial_size=125
validate_silence=1
validate_uniform=1
validate_scenechange=1
ms_audio_delay=5
volume_slip=40
skip_b_frames=0
max_repair_size=200
disable_heuristics=4
output_edl=1
max_volume=100
min_silence=12
punish=0					; Compare to average for sum of 1=brightness, 2=uniform 4=volume, 8=silence, 16=schange, set to 0 to disable
punish_threshold=1.3			; Multiply when amount is above average * punish_threshold
punish_modifier=2			; When above average * threshold multiply score by this value
intelligent_brightness=0                ; Set to 1 to use a USA specific algorithm to tune some of the settings, not adviced outside the USA
logo_percentile=0.92			; if more then this amount of logo is found then logo detection will be disabled
logo_threshold=0.75
connect_blocks_with_logo=1
logo_filter=4
cut_on_ar_change=0			; set to 1 if you want to cut also on aspect ratio changes when logo is present, set to 2 to force cuts on aspect ratio changes. set to 0 to disable
Post Reply