It also works for RAI 1, RAI 2 and RAI3 (didn't test others) but some tuning could be done because sometimes there are small TG1 / TG2 news and they aren't detected as ads (probably because of their duration)
The turning point for this working was to totally disable the logo detection as a method, because the logo is always present.
here's the ini:
Code: Select all
verbose=10
detect_method=253
delete_logo_file=1
use_existing_logo_file=1
output_framearray=1
output_debugwindow=1 ; Only for tuning, to be replaced later
non_uniformity=100 ; Only for tuning, to be replaced later
max_avg_brightness=20
test_brightness=40
intelligent_brightness=0
logo_present_modifier=0
punish_no_logo=0
min_black_frames_for_break=3
max_volume=100
maxbright=30
max_brightness=30
min_commercial_size=4
min_commercialbreak=15
max_commercialbreak=600
max_commercial_size=125
validate_silence=1
validate_uniform=1
validate_scenechange=1
ms_audio_delay=5
volume_slip=40
skip_b_frames=0
max_repair_size=200
disable_heuristics=4
output_edl=1
max_volume=100
min_silence=12
punish=0 ; Compare to average for sum of 1=brightness, 2=uniform 4=volume, 8=silence, 16=schange, set to 0 to disable
punish_threshold=1.3 ; Multiply when amount is above average * punish_threshold
punish_modifier=2 ; When above average * threshold multiply score by this value
intelligent_brightness=0 ; Set to 1 to use a USA specific algorithm to tune some of the settings, not adviced outside the USA
logo_percentile=0.92 ; if more then this amount of logo is found then logo detection will be disabled
logo_threshold=0.75
connect_blocks_with_logo=1
logo_filter=4
cut_on_ar_change=0 ; set to 1 if you want to cut also on aspect ratio changes when logo is present, set to 2 to force cuts on aspect ratio changes. set to 0 to disable