ignore_side setting

To discuss the tuning of comskip and for posting your ini files
Post Reply
gonzo90017
Posts: 2
Joined: Mon Aug 03, 2015 4:07 am

ignore_side setting

Post by gonzo90017 » Mon Aug 03, 2015 4:16 am

I was looking at the .ini file, and was wondering if this setting is usable. I've noticed in my US OTA programming that most if not all of the programming always has the logo on the right side. So if this option is usable I would like to know. And if so what to set it to so it can ignore the left side.

erik
Site Admin
Posts: 3297
Joined: Sun Aug 21, 2005 3:49 pm

Re: ignore_side setting

Post by erik » Mon Aug 03, 2015 5:13 pm

When you set
verbose=10
and run comskip the log file will show all available settings.
If you need one, copy it to the ini file.

Or you can try the comskip ini editor.

I do not know anymore if I ever did implement this
You can at least ignore the top or bottom half of the screen when searching for logo

gonzo90017
Posts: 2
Joined: Mon Aug 03, 2015 4:07 am

Re: ignore_side setting

Post by gonzo90017 » Tue Aug 04, 2015 1:18 am

The problem is that the .ini editor doesn't know if the setting was ever implemented either...

erik
Site Admin
Posts: 3297
Joined: Sun Aug 21, 2005 3:49 pm

Re: ignore_side setting

Post by erik » Tue Aug 04, 2015 6:17 pm

There is a
ignore_side=
defining the pixels to ignore starting from the side but this parameter works equal on both sides
So the answer is: no

Post Reply