ignore_side setting
-
- Posts: 2
- Joined: Mon Aug 03, 2015 4:07 am
ignore_side setting
I was looking at the .ini file, and was wondering if this setting is usable. I've noticed in my US OTA programming that most if not all of the programming always has the logo on the right side. So if this option is usable I would like to know. And if so what to set it to so it can ignore the left side.
Re: ignore_side setting
When you set
verbose=10
and run comskip the log file will show all available settings.
If you need one, copy it to the ini file.
Or you can try the comskip ini editor.
I do not know anymore if I ever did implement this
You can at least ignore the top or bottom half of the screen when searching for logo
verbose=10
and run comskip the log file will show all available settings.
If you need one, copy it to the ini file.
Or you can try the comskip ini editor.
I do not know anymore if I ever did implement this
You can at least ignore the top or bottom half of the screen when searching for logo
-
- Posts: 2
- Joined: Mon Aug 03, 2015 4:07 am
Re: ignore_side setting
The problem is that the .ini editor doesn't know if the setting was ever implemented either...
Re: ignore_side setting
There is a
ignore_side=
defining the pixels to ignore starting from the side but this parameter works equal on both sides
So the answer is: no
ignore_side=
defining the pixels to ignore starting from the side but this parameter works equal on both sides
So the answer is: no